Moxa Technologies ICF-1170I Series Bedienungsanleitung

ICF-1170I Series

Quick Installation Guide

First Edition, September 2009

Reproduction without permission is prohibited.

Fl.4, No.135, Lane 235, Pao-Chiao Rd.

Shing Tien City, Taipei, Taiwan, R.O.C.

TEL: +886-2-8919-1230

P/N: 1802011700010

RSPSupply - 1-888-532-2706 - www.RSPSupply.com

http://www.RSPSupply.com/p-9305-Moxa-ICF-1170I-M-ST.aspx

- 2 -

Overview

Introduction

The ICF-1170I series is a CAN-to-fiber optic converter that secures data

transmission by using fiber optic transmission to provide complete isolation

and protection against EMI.

The ICF-1170I series can separate and protect critical segments of the system

from the rest of the CAN network and is protocol independent, allowing it to

work with all of the different CAN protocols and frame lengths.

To connect two CAN devices with fiber optic cable, two ICF-1170I series

converters are required.

Why Convert CAN to Fiber?

Fiber communication not only extends the communication distance, but also

provides also provides other advantages:

•IMMUNITY FROM ELECTRICAL INTERFERENCE

Fiber is not affected by electromagnetic interference or radio frequency

interference, and consequently provides a clean communication path and

is immune to cross-talk.

•INSULATION

Optical fiber is an insulator; the glass fiber eliminates the need for using

electric current as the communication medium.

•SECURITY

Optical fiber provides better security compared to traditional electrical

signals transmitted through a wire or radio waves transmitted through the

air. Since the light rays travel down the center of the fiber, it is extremely

difficult for them to escape. In addition, it is nearly impossible to tap into

a fiber optic cable, and even if a tap is successful, it is possible to detect

the tap by monitoring the optical power received at the termination point.

•RELIABILITY AND MAINTENANCE

Fiber is immune to adverse temperature and moisture conditions, does not

corrode or lose its signal, and is not affected by short circuits, power

surges, or static electricity.

Fiber Test Mode

The ICF-1170I supports a special feature called Fiber Test Mode, which is

easily activated with a DIP switch on the ICF-1170I’s outer panel.

Fiber Test Mode can be used to test the fiber cable between two ICF-1170I

units, and provides a simple way to determine if the fiber cable is transmitting

data correctly.

When in Fiber Test Mode, the fiber transceiver (TX) will send out a data

signal continuously and the “Fiber TX” LED will light up. On the other side of

the connection, when the ICF-1170I fiber transceiver (RX) receives the data

signal form the TX side, the “Fiber RX” LED will light up.

RSPSupply - 1-888-532-2706 - www.RSPSupply.com

http://www.RSPSupply.com/p-9305-Moxa-ICF-1170I-M-ST.aspx

- 3 -

Alarm contact output

The ICF-1170I supports dual power inputs for redundancy. When one power

input fails, the relay will be triggered. Be sure to install the dual power inputs

for the ICF-1170I series, and choose the correct relay output when connecting

the alarm.

Features

yTransmit up to 2 km

yConvert CAN signals to fiber and fiber to CAN signals

yCAN transfer rate up to 1 Mbps

yDual power inputs for redundancy

yDIP switch for 120 Ωterminal resistance

yDIP switch for fiber test mode

yWide temperature model available for -40 to 85°C environments

Package Checklist

Before installing the ICF-1170I series, verify that the package contains the

following items:

yICF-1170I series CAN-to-fiber Converter

yQuick Installation Guide

yWarranty Card

NOTE: Please notify your sales representative if any of the above items are

missing or damaged.

Fiber TX LED

Fiber Test DIP

switch

RSPSupply - 1-888-532-2706 - www.RSPSupply.com

http://www.RSPSupply.com/p-9305-Moxa-ICF-1170I-M-ST.aspx

- 4 -

Mounting Dimensions (Unit: mm)

ICF-1170-M-ST

Top View

Front View

Fiber Port

LED

RS-422/485

OP Mode Switch

ATTENTION

Electrostatic Discharge Warning!

To protect the product from damage due to electrostatic

discharge, we recommend wearing a grounding device when

handling your ICF-1170 series.

RSPSupply - 1-888-532-2706 - www.RSPSupply.com

http://www.RSPSupply.com/p-9305-Moxa-ICF-1170I-M-ST.aspx

- 5 -

Mounting

The aluminum DIN-Rail attachment plate should be fixed to the back panel of

the ICF-1170I series when you take it out of the box. If you need to reattach

the DIN-Rail attachment plate to the ICF-1170I, make sure the stiff metal

spring is situated towards the top, as shown in the figures below.

Step 1:

Insert the top of the DIN-Rail into

the slot just below the stiff metal

spring.

Step 2:

The DIN-Rail attachment unit will

snap into place as shown below.

Metal spring

DIN-Rail

Metal spring

DIN-Rail

To remove the ICF-1170I series from the DIN-Rail, simply reverse Steps 1 and

2 above.

Fiber Cable

ST-Port Pinouts ST-Port to ST-Port Cable Wiring

Cable Wiring

A A

B B

ATTENTION

This is a Class 1 laser/LED product. Do not stare into the

laser beam.

Switch Settings

There are 2 DIP switches on the front panel of the ICF-1170I series.

120 ΩTerminator Switch 1

Enable ON

Disable OFF (default)

Fiber Test Mode Switch 2

Enable ON

Disable OFF (default)

RSPSupply - 1-888-532-2706 - www.RSPSupply.com

http://www.RSPSupply.com/p-9305-Moxa-ICF-1170I-M-ST.aspx

- 6 -

LED Indicators

There are 4 LEDs on the front panel of the ICF-1170I.

LED Color Function

PWR 1 Green Steady ON: Power source 1 is ON.

PWR 2 Green Steady ON: Power source 2 is ON.

Fiber Tx Green When sending CAN data to the fiber port.

Fiber Rx Orange When receiving data from the fiber port.

Typical CAN Application

Specifications

CAN Communication

CAN Bus Interface: ISO 11898-2, Terminals (CAN_H, CAN_L,

CAN_GND)

Protocols Supported: CAN 2.0A and 2.0B (ISO 11898-2)

CAN Connector: 3-pin removable screw terminal x1

Termination Resistor: Dip switch selector for 120 Ωterminal

resistor

Baudrate: Up to 1 Mbps

System Delay: 150 ns

Isolation Protection: 2 KV

Transmission Length: Max 2 KM (depends on the data rate and the

protocol used)

LED Indicators: PWR1, PWR2, Fiber TX, Fiber RX

Note: The transmission distance is limited by the signal rate, as mentioned in

the ISO 11898-2 standard.

Fiber Communication

Connector Type ST (multi-mode) fiber ports x 2

Support Cable : 50/125, 62.5/125, or 100/140 μm

(multimode)

Wavelength 850 nm

TX Output Multimode > -5 dBm

RX Sensitivity Multimode -20 dBm

Environmental Limits

Operating Temperature 0 to 60°C (32 to 142°F), 5 to 95 % RH

CAN coppe

CAN

Node

ICF-1170I ICF-1170I

CAN

Node CAN

Node

CAN fibe

RSPSupply - 1-888-532-2706 - www.RSPSupply.com

http://www.RSPSupply.com/p-9305-Moxa-ICF-1170I-M-ST.aspx

- 7 -

-40 to 85°C (-40 to 167°F) for T model

Storage Temperature -40 to 85°C (-4 to 185°F), 5 to 95 % RH

Power

Input Power Voltage 12 to 48 VDC dual power input for

redundant power

Alarm contact 1 relay output with current carrying of 1

A@24VDC

Mechanical Specifications

Dimensions 30.3 × 70 × 115 mm

Material Aluminum (1 mm)

Gross Weight 135 g

Regulatory Approvals

CE Class A

FCC Part 15 sub Class A

UL UL-508

TÜV EN 60950-1

EMI EN55022 1998, Class A

EMS EN61000-4-2 (ESD), Criteria B, Level 4

EN61000-4-3 (RS), Criteria A, Level 2

EN61000-4-4 (EFT), Criteria B, Level 4

EN61000-4-5 (Surge), Criteria B, Level 2

EN61000-4-6 (CS), Criteria B, Level 2

En61000-4-8 (PFMF), Criteria A, Level 3

Freefall IEC 60068-2-32

MTBF 792085 hrs

Ordering Information

Available models

•ICF-1170I-M-ST: CAN to fiber converter, multi-mode, ST connector.

•ICF-1170I-M-ST-T: CAN to fiber converter, multi-mode, ST connector,

-40 to 85°C.

Technical Support Contact Information

www.moxa.com/support

Moxa Americas:

Toll-free: 1-888-669-2872

Tel: +1-714-528-6777

Fax: +1-714-528-6778

Moxa China (Shanghai office):

Toll-free: 800-820-5036

Tel: +86-21-5258-9955

Fax: +86-10-6872-3958

Moxa Europe:

Tel: +49-89-3 70 03 99-0

Fax: +49-89-3 70 03 99-99

Moxa Asia-Pacific:

Tel: +886-2-8919-1230

Fax: +886-2-8919-1231

RSPSupply - 1-888-532-2706 - www.RSPSupply.com

http://www.RSPSupply.com/p-9305-Moxa-ICF-1170I-M-ST.aspx

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Moxa Technologies Medienkonverter Handbücher

Moxa Technologies

Moxa Technologies NPort DE-311 Handbuch

Moxa Technologies

Moxa Technologies UPort 2000 Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies IMC-21GA Handbuch

Moxa Technologies

Moxa Technologies VPort 254 Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies TCF-142-S-ST-RM Bedienungsanleitung

Moxa Technologies

Moxa Technologies IMC-101G Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies VPort 364 Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies UPORT 1400 series Bedienungsanleitung

Moxa Technologies

Moxa Technologies TCC-100 Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies TCF-142 Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies NPort 5110A Bedienungsanleitung

Moxa Technologies

Moxa Technologies TCF-142-RM Series Handbuch

Moxa Technologies

Moxa Technologies VPort 364A Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies ICF-1170I-M-ST Bedienungsanleitung

Moxa Technologies

Moxa Technologies IMC-P101 Series Handbuch

Moxa Technologies

Moxa Technologies VPort 451 Bedienungsanleitung

Moxa Technologies

Moxa Technologies VPort 2141 Bedienungsanleitung

Moxa Technologies

Moxa Technologies TCF-142-S Bedienungsanleitung

Moxa Technologies

Moxa Technologies NPort Z2150 Bedienungsanleitung

Moxa Technologies

Moxa Technologies NPort 5100A Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies TCF-141-S Bedienungsanleitung

Moxa Technologies

Moxa Technologies VPort D361 Bedienungsanleitung

Moxa Technologies

Moxa Technologies PTC-101 Series Bedienungsanleitung

Moxa Technologies

Moxa Technologies IMC-101 Series Handbuch

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung