S.R.Smith 6004 Series Bedienungsanleitung

79-15022-00 REV. E2 www.srsmith.com Page 1 of 4

10.75”

MAXIMUM SOIL HEIGHT:

DO NOT ALLOW FILL TO

EXCEED THIS LEVEL!

12”

9.75”10.5”

22.75”

4”

13”

11.5”

6004 SERIES

WARNING: DO NOT INSTALL

WITHIN 1.5M (5 FT.) OF A

POOL, SPA, OR HOT TUB.

ADVERTISSEMENT: NE PAS

INSTALLER A MOINS DE 1,5M

D’UNE PISCINE OU D’UNE

CUVE DE RELAXATION.

INSTALLATION MANUAL

ELECTRICAL

Voltage required: 120VAC 60Hz

Power consumption: 200 Watts max

Start current load: 4.4 amps

Current usage: 1.8 amps

LAMP

Type: Metal-Halide, proprietary design

Lamp life: 6000 hrs average

Cool down restrike period: 3 minutes

Replacement p/n: Y20-6000

SPECIFICATIONS

CONSTRUCTION

Case: High Impact Polycarbonate

Ventilation: 110 cu ft/min air volume

Acoustic rating: 50dB(A)

Weight: 20 lbs.

79-15022-00 REV. E2 www.srsmith.com Page 2 of 4

ELECTRICAL CONNECTIONS

6004 SERIES

120v 60Hz ONLY

MANUAL CONTROL

COLOR WHEEL

POWER

COLOR WHEEL

OFF

POWER

OFF

EXTERNAL AUTO CONTROL

COLOR WHEEL POWER

OPTIONAL RM6000 CONTROL

COLOR WHEEL POWER

TOGGLE SWITCH POSITIONS

EXTERNAL AUTO CONTROL HOOK-UP FOR COLOR WHEEL

For WPC, Jandy Aqualink, Compool, etc.

Run a 120V hot wire to the illuminator from a second relay in

the control’s sub panel for the color wheel control. Connect

this wire to the folded brown wire with fuse. Place the Color

Wheel toggle switch in the bottom position.

EXTERNAL

COLOR WHEEL

CONTROL

(BROWN)

OPTIONAL RM6000 CONTROL

COLOR WHEEL POWER

TOGGLE SWITCH POSITIONS

OPTIONAL RM6000 WIRELESS REMOTE

This RM6000 Automatic Operating System package is

specifically designed for the Lifetime Illuminator™ fiber

optic illuminator and should not be modified or

adapted in any way. This is an electric component

and should only be installed by a qualified technician.

Please follow the instructions carefully. RANGE IS

APPROXIMATELY 75 FEET DEPENDING ON

CONDITIONS.

Light On Light Off

Color Wheel Start Color Wheel Stop

79-15022-00 REV. E2 www.srsmith.com Page 3 of 4

REFER TO THE DIAGRAM ON THE FRONT OF THIS MANUAL FOR THE FOLLOWING

PROCEDURES

1) SEE OUR GENERAL INSTALLATION MANUAL FOR FIBER AND CONDUIT INSTALLATION

IN THE POOL. THIS MANUAL COVERS THE 6000 SERIES ILLUMINATOR INSTALLATION

ONLY.

2) CUT THE FIBER CONDUITS SO THEY WILL ENTER THE INSTALLATION BASE

APPROXIMATELY HALFWAY. CUT THE ELECTRICAL CONDUIT SO IT WILL PROTRUDE

PAST THE CONDUIT HOLE 1” OR LESS (FIG A.). PULL ALL FIBER OPTIC CABLES AT

LEAST 12” THROUGH THE TOP OF THE INSTALLATION BASE.

3) FOLLOW THE PORT ASSEMBLY PROCEDURES ON THE BACK OF THIS MANUAL.

4) PLACE THE CHASSIS ON THE INSTALLATION BASE. SECURE THE ILLUMINATOR WITH

THE TWO SCREWS SUPPLIED. SNAP THE PORT INTO THE CLIP ON THE CHASSIS. MAKE

MAKE SURE IT SEATS FIRMLY INTO THE CLIP (FIG B.).

5) MAKE THE ELECTRIC CONNECTIONS AS SHOWN ON THE PREVIOUS PAGE. MAKE SURE

NO WIRES INTERFERE WITH THE COOLING FAN OR COLOR WHEEL.

6) a) IF INSTALLING IN THE GROUND:

BACKFILL HALFWAY UP THE INSTALLATION BASE. ALLOW AMPLE HEIGHT FOR TOP

SOIL AND LANDSCAPING. DO NOT ALLOW THE VENTS ON THE BOTTOM OF THE

ILLUMINATOR TO BE BLOCKED. THIS WILL CAUSE THE ILLUMINATOR TO OVERHEAT

AND SHUT OFF.

b) IF SURFACE MOUNTING:

USE PROPER SECURING SCREWS FOR THE SURFACE TYPE YOU ARE ATTACHING TO,

USING THE 2 HOLES PROVIDED ON THE BASE. EXAMPLE: FOR CONCRETE, USE

PROPER CONCRETE SCREWS. FOR WOOD SURFACE, USE PROPER WOOD SCREWS.

FIG A.

APPROVED CONDUITS FOR USE WITH FIBER

OPTIC CABLES

•White PVC conduit/pipe SCH 40 or SCH 80

•Gray PVC conduit/pipe SCH 40 or SCH 80

•Flexible PVC pipe

•Black poly pipe

•Any other suitable conduit

FIBER CONDUIT HOLE

AT LEAST 12” OF FIBER

MUST BE PROTRUDING PAST HOLE

ELECTRICAL CONDUIT HOLE

ELECTRIC CONDUIT SHOULD

PROTRUDE 1” OR LESS

USE SWEEP ELLS OR HEAT BEND

FOR GENTLE RADIUS

FIG B.

INSTALLATION GUIDELINES

79-15022-00 REV. E2 www.srsmith.com Page 4 of 4

SMALL

UP TO 100 FIBERS

MEDIUM LARGE

101 TO 200 201 TO 300

XTRA LARGE

301 TO 400 401 TO 450

MAXIMUM

TIP SIZES

PORT ASSEMBLY/FIBER TERMINATION

A) Insure that the total fiber count of

all fiber tubings is 450 or less. If

you have more than 450 individual

fibers, you will need a second

illuminator. The maximum

capacity of the 6004 series port is

450 fibers (optional CCS-600 for

expanding port to 600 fibers sold

separately).

B) Insert the proper size tip into the

port and twist with pliers to lock

(fig. 1).

C) Strip back all fiber casings no less

than 4 inches (fig. 2). Take care

not to nick the fibers.

D) Insert the bare fibers into the port

so ALL fibers protrude past the

port tip (fig. 3). Tighten the port

compression nut down on the

fiber casing (fig. 4).

E) IMPORTANT: If the port tip is not

completely full, insert scrap

individual fibers into the tip until it

is completely full (fig. 5). This will

keep the lit fibers perpendicular to

the lamp, and prevent the fibers

from overheating.

F) Plug in the hot knife (p/n FS-118)

and allow it to heat up. Apply firm

downward pressure on the fibers,

with the blade touching the port

tip at a slight angle (fig. 6.) Do not

saw at the fibers. Allow the heat

of the knife to slowly trim the

fibers. Ease the pressure as the

knife almost completes the cut.

Unplug the hot knife and place it

in a safe place to cool.

Andere S.R.Smith Beleuchtungsausrüstung Handbücher

S.R.Smith

S.R.Smith R Series Bedienungsanleitung

S.R.Smith

S.R.Smith PT-6001 Power Tower Bedienungsanleitung

S.R.Smith

S.R.Smith rogue2 Bedienungsanleitung

S.R.Smith

S.R.Smith TURBOTWISTER Gebrauchsanweisung

S.R.Smith

S.R.Smith SlideAway Installationsanleitung

S.R.Smith

S.R.Smith TYPHOON Gebrauchsanweisung

S.R.Smith

S.R.Smith LM10 Bedienungsanleitung

S.R.Smith

S.R.Smith FRONTIER II Bedienungsanleitung

S.R.Smith

S.R.Smith SWIM CLUB II FUNSLIDE Bedienungsanleitung

S.R.Smith

S.R.Smith CYCLONE Gebrauchsanweisung

S.R.Smith

S.R.Smith heliX2 Gebrauchsanweisung

S.R.Smith

S.R.Smith BYOS 2 Programmierhandbuch

S.R.Smith

S.R.Smith EDGE 6 Programmierhandbuch

S.R.Smith

S.R.Smith SRS-TX-30 Bedienungsanleitung

S.R.Smith

S.R.Smith AQUABLAST Bedienungsanleitung

S.R.Smith

S.R.Smith VORTEX Gebrauchsanweisung

S.R.Smith

S.R.Smith ROGUE GRAND RAPIDS Bedienungsanleitung

S.R.Smith

S.R.Smith rogue2 Bedienungsanleitung

S.R.Smith

S.R.Smith Power Tower PT-6002 Bedienungsanleitung

S.R.Smith

S.R.Smith Star Series Bedienungsanleitung

S.R.Smith

S.R.Smith pLX-PL60 Kurzanleitung

S.R.Smith

S.R.Smith PAL Series Bedienungsanleitung

S.R.Smith

S.R.Smith multiLift 2 Leitfaden

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung