S.R.Smith SRS-TX-30 Bedienungsanleitung

79-15259-00 www.srsmith.com Page 1 of 7

FOR USE WITH POOL AND SPA PRODUCTS

SRS-TX-30

Rated for use on 110/120VAC 60Hz applications

Installation Instructions: Read these instructions in its

entirety before performing any installation work.

4008814

Conforms to UL STD 379;

Certified to CSA STD C22.2 #218.1

OFF

ISOLATION

COVE

79-15259-00 www.srsmith.com Page 2 of 7

The SRS-TX-30 consists of the following parts:

Item # Qty. Component Part # Description

1 1 10-15078-05 Screw, 8-32, 1/4" length

2 1 02-15285-00 Relay Cover

3 1 02-15314-00 Bracket Mount, WIR-TRAN

4 2 10-15031-03 Screw, 6-32, 1/4" length

5 2 10-15089-07 M3 Screw, 14mm length

6 4 10-15089-01 M3 Screw, 4mm length

7 2 11-15005-00 Nut, 6-32, Star Lock

8 1 02-15287-00 Bracket, Mounting Plate

9 1 38-15000-00 Rocker Switch, ON / OFF

10 1 41-15004-08 8 Position Terminal Block

11 1 44-15037-00 Transformer, 12VAC

12 1 A12664 Fuse Holder, 250V, 10A max

13 2 41-15005-00 Push-Wire Connector, 6-Conductor, (not shown)

14 1 36-15015-00 Fuse,250V, 2.0A, 1-1/4"x1/4", Fast-Blow (not shown)

15 1 02-15340-00 Bracket, Isolation Wiring Cover, (not shown)

79-15259-00 www.srsmith.com Page 3 of 7

Basic safety precautions should be observed when operating the SRS-TX-30 product and other

associated equipment.

1. A qualified electrician must install the SRS-TX-30 in accordance to the National and Local

Electrical Codes.

2. The SRS-TX-30 must not be less than 5 feet (3 meters in Canada) from inside edge of pool.

ONLY USE COPPER CONDUCTORS.

3. Do not exceed the maximum ratings of individual components, wiring devices, and current

carrying capacity of conductors.

4. For the bonding, grounding, installing, and wiring of underwater lights to the SRS-TX-30 refer to

Article 680 of the National Electrical Code or Article 68 of the Canadian Electrical Code.

5. This device should never operate equipment that could cause property damage, bodily injury, or

death should it be activated unexpectedly.

6. Never allow children to operate the SRS-TX-30 unsupervised.

IMPORTANT SAFETY INFORMATION

ELECTRICAL RATINGS

Do not exceed the maximum electrical output rating of 30W for the SRS-TX-30. Install a 20Amp,

120VAC GFCI Circuit Breaker for power input. Refer to pages 4 and 5 for installation instructions.

FCC WARNING

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by S.R. Smith could void the user's authority to

operate the equipment.

FUSE REPLACEMENT

To help protect internal parts, the SRS-TX-30 is equipped with a fuse. In the event that the fuse needs

replacement, only use a 250V, 2A Fast-Blow (fast acting) type similar to what is equipped from the

factory. You may also order SR Smith part number 36-15015-00 from your local authorized

distributor.

DANGER – FAILURE TO FOLLOW THESE WARNINGS, INSTRUCTIONS AND THE

OWNER’S MANUAL MAY RESULT IN SERIOUS INJURY OR DEATH

SAVE THESE INSTRUCTIONS!

79-15259-00 www.srsmith.com Page 4 of 7

WARNING

• TURN OFF INCOMING POWER BEFORE SERVICING EQUIPMENT.

• ALL INSTALLATION AND MAINTENANCE WORK MUST BE PERFORMED BY

QUALIFIED ELECTRICAL PERSONEL ONLY.

• GFCI BREAKER MUST BE USED TO CONNECT SRS-TX-30 TO INPUT POWER.

• VERIFY ALL ELECTRICAL RATINGS BEFORE INSTALLATION IS COMPLETE.

FOLLOW PROPER WIRING PRACTICES IN ACCORDANCE WITH ALL LOCAL

REGULATORY REQUIREMENTS.

WIRING INSTRUCTIONS

LOCATION

The SRS-TX-30 is housed in a Type 3R rainproof enclosure and can be mounted anywhere

between the pool equipment and the breaker panel.

GFCI

Power Connections:

To wire the SRS-TX-30 use insulated

COPPER wire only, 12 gauge minimum. Run

a ½” to ¾” conduit from the main breaker

panel to the right most bottom conduit knock

out of the SRS-TX-30. Pull appropriate wires

from the main breaker panel to the SRS-TX-

30 unit. To make the input power

connections, unscrew the Isolation Cover

covering the right side of the terminal strip

and remove 3/8 inches of insulation from the

wire ends. Insert the bare end of each wire

under the pressure plate of the appropriate

screw terminal (Power Input 120V AC,

NEUTRAL). Use 1/8-in. flat head

screwdriver to tighten terminal screws firmly

(10.0 in-lbs. minimum). Connect the house

ground line to the Input Ground line on the

SRS-TX-30. Install a 20 Amp max GFCI

circuit breaker in the main breaker panel and

connect the HOT wires from the SRS-TX-30.

As a final step replace the Isolation Cover

over the Input wire terminals and reattach the

grounding attachment screw. Use provided

cable tie to secure the Input Wires to the

Isolation cover.

GROUND

EUTRAL

120V LINE INPUT

EUTRAL FROM

GFCI LOAD

120V POWER

FROM GFCI LOAD

OFF

79-15259-00 www.srsmith.com Page 5 of 7

Hooking up 12VAC Light to Circuit 1

To connect a 12VAC light to the Circuit 1

switch, pull wires from the low voltage lighting

product to the SRS-TX-30 through conduits

connected to the left bottom of the SRS-TX-30.

Some lights may identify a 12VAC Hot and

Neutral lead though this is not typical with

12VAC low voltage lighting as there is no

polarity. If it does identify specific leads, then

follow the below instructions.

As illustrated, connect the light that will be

operated by the Rocker Switch to the Light Hot

terminal. Connect the Light Neutral to the

Light Neutral terminal. Do not exceed demand

of 30 watts @ 12V.

Two UL listed wire nuts have been included to

simplify connection of up to five lights to the

terminal strip. If conductors are stranded

18AWG wire or smaller, use a crimping tool

and the supplied copper wire ferrules for a

secure installation.

LIGHT HOT, 12VAC

LIGHT NEUTRAL, 12VAC

OFF

79-15259-00 www.srsmith.com Page 6 of 7

SRS-TX-30 ROCKER SWITCH OPERATION

The SRS-TX-30 receiver box houses one rocker

switch to control the operation of the unit. The switch

must be in the DOWN position before powering on for

the first time. To turn ON the 12VAC light connected

to the SRS-TX-30, flip the rocker switch UP or to the

ON position. When the rocker switch is in the ON

position, low voltage power is applied to the 12VAC

light/s connected to the SRS-TX-30. To turn OFF the

12VAC light, flip the rocker switch to the BOTTM or

OFF position. To change the color mode on a SR

Smith LED light, simply toggle OFF, ON within 1

second and the light will advance to the next color

mode.

OPERATING INSTRUCTIONS

NOTE: Switch is shown in the ON position.

OFF

79-15259-00 www.srsmith.com Page 7 of 7

Inhaltsverzeichnis

Andere S.R.Smith Beleuchtungsausrüstung Handbücher

S.R.Smith

S.R.Smith ROGUE GRAND RAPIDS Bedienungsanleitung

S.R.Smith

S.R.Smith VORTEX Gebrauchsanweisung

S.R.Smith

S.R.Smith PAL Series Bedienungsanleitung

S.R.Smith

S.R.Smith TURBOTWISTER Gebrauchsanweisung

S.R.Smith

S.R.Smith rogue2 Bedienungsanleitung

S.R.Smith

S.R.Smith Power Tower PT-6002 Bedienungsanleitung

S.R.Smith

S.R.Smith SWIM CLUB II FUNSLIDE Bedienungsanleitung

S.R.Smith

S.R.Smith BYOS 2 Programmierhandbuch

S.R.Smith

S.R.Smith R Series Bedienungsanleitung

S.R.Smith

S.R.Smith multiLift 2 Leitfaden

S.R.Smith

S.R.Smith heliX2 Gebrauchsanweisung

S.R.Smith

S.R.Smith PT-6001 Power Tower Bedienungsanleitung

S.R.Smith

S.R.Smith CYCLONE Gebrauchsanweisung

S.R.Smith

S.R.Smith EDGE 6 Programmierhandbuch

S.R.Smith

S.R.Smith Star Series Bedienungsanleitung

S.R.Smith

S.R.Smith LM10 Bedienungsanleitung

S.R.Smith

S.R.Smith SlideAway Installationsanleitung

S.R.Smith

S.R.Smith rogue2 Bedienungsanleitung

S.R.Smith

S.R.Smith 6004 Series Bedienungsanleitung

S.R.Smith

S.R.Smith pLX-PL60 Kurzanleitung

S.R.Smith

S.R.Smith AQUABLAST Bedienungsanleitung

S.R.Smith

S.R.Smith FRONTIER II Bedienungsanleitung

S.R.Smith

S.R.Smith TYPHOON Gebrauchsanweisung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung