Clarke CBO3-12 Bedienungsanleitung

OPERATION & MAINTENANCE

INSTRUCTIONS

ORIGINAL INSTRUCTIONS GC0421 - rev 1

AUTOMATIC BATTERY CHARGER /

MAINTAINER

MODEL NO: CBO3-12

PART NO: 6267015

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE product.

Before attempting to use this product, please read this manual thoroughly and

follow the instructions carefully. In doing so you will ensure the safety of yourself

and that of others around you, and you can look forward to your purchase

giving you long and satisfactory service.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt which will be

required as proof of purchase.

This guarantee is invalid if the product is found to have been abused or

tampered with in any way, or not used for the purpose for which it was

intended.

Faulty goods should be returned to their place of purchase, no product can

be returned to us without prior permission.

This guarantee does not effect your statutory rights.

ENVIRONMENTAL RECYCLING POLICY

Through purchase of this product, the customer is taking on the

obligation to deal with the WEEE in accordance with the WEEE

regulations in relation to the treatment, recycling & recovery and

environmentally sound disposal of the WEEE.

In effect, this means that this product must not be disposed of with general

household waste. It must be disposed of according to the laws governing

Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal

facility.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SAFETY INSTRUCTIONS

• Always keep the charger in good condition.

• Keep the charger clean.

• Always keep the work area clean and tidy and make sure that there is

sufficient lighting.

• Use eye protection (standard spectacles are not adequate) and

protective clothing. Do not touch your eyes while working with

batteries.

• Remove loose clothing, watches, and any jewellery, and contain long

hair. A lead acid battery can cause a short-circuit current sufficient to

weld metal to metal, which will cause dangerous burns.

• Read the vehicle manufacturers instruction manual for specified

battery charging instructions.

• Disconnect the battery and move it to a safe, dry level area for

charging. If the battery cannot be removed, refer to manufacturers

handbook.

• Clean the clamps and battery terminals to remove oxidation.

• When you connect the clamps to the battery, make sure that you

follow the correct polarity. Red is Positive (+) and Black is Negative (-).

• DO NOT pull or lift the charger by its cables.

• DO NOT pull plugs from the sockets by the power cable.

• DO NOT try to charge a non-rechargeable battery.

• DO NOT use the charger for something other than that for which it is

designed.

• DO NOT let the clamps touch each other when the power is on.

• DO NOT get the charger wet or use it in damp or wet locations or areas

where there is condensation.

WARNING: DO NOT USE ON ANY OTHER BATTERIES APART FROM THOSE

MENTIONED IN THE SPECIFICATION TABLE ON PAGE 10 .

WARNING: DISCONNECT THE CHARGER FROM THE MAINS POWER BEFORE

MAKING OR BREAKING DC CONNECTION, SERVICING OR PERFORMING

ANY MAINTENANCE.

WARNING: ENSURE THERE ARE NO SOURCES OF IGNITION NEAR THE

WORK AREA I.E. NAKED FLAMES, SPARKS, CIGARETTES, FLAME HEATERS

ETC AS THE CHARGING PROCESS PRODUCES EXPLOSIVE GASES.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

• DO NOT operate the charger if there is any visible damage.

• DO NOT try to modify or open the charger.

• DO NOT charge the battery with the engine running.

• DO NOT charge a frozen battery.

• When not in use disconnect the charger from the power supply and

keep in a safe, dry area.

• DO NOT let untrained persons operate the charger. It is not intended for

use by persons with reduced physical, sensory or mental capabilities, or

lack of experience and knowledge, unless they have been given

instruction concerning the use of the charger and are supervised by a

person responsible for their safety.

• Keep children and unauthorised persons away from the working area.

• Follow these instructions and those of the battery and vehicle

manufacturers.

PERSONAL PRECAUTIONS

• Ensure there is another person within hearing range of your voice, or

close enough to come to your aid, should a problem arise.

• Have fresh water and soap nearby in case battery acid contacts skin,

clothing or eyes.

• Wash immediately with soap and water if battery acid contacts skin or

clothing. If acid enters the eye, flush the eye immediately with cool,

clean running water for at least 15 minutes and seek immediate

medical attention.

• DO NOT smoke or allow a flame in the vicinity of battery or engine.

SAFETY SYMBOLS

Read all

instructions before

use

For indoor use only.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply

through an approved BS1363/A plug fitted with a BS1362 fuse.

If the plug has to be changed because of damage, it must be removed and a

replacement fitted, following the wiring instructions shown below. The old plug

must be discarded safely, as insertion into a power socket could cause an

electrical hazard.

• The BLUE wire must be

connected to the

terminal which is

marked N or coloured

black.

• The BROWN wire must

be connected to the

terminal which is

marked L or coloured

red.

We strongly recommend that this machine is connected to the mains supply

via a Residual Current Device (RCD)

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs

yourself.

This symbol indicates that this is a Class II product, and does not require

an earth connection.

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS

SUPPLY.

WARNING: WIRES IN THE MAINS LEAD ARE COLOURED IN

ACCORDANCE WITH THE FOLLOWING CODE: BLUE = NEUTRAL,

BROWN = LIVE.

Plug must be BS1363/A approved.

Always fit

Ensure that the outer sheath of

Neutral

(Blue)

Live

(Brown)

a 5 Amp

the cable is firmly held by the clamp

fuse.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CONNECTIONS

1. The charger should be connected to the battery or the vehicle accessory

(cigar lighter) socket, before connecting it to the mains supply.

IMPORTANT: Check the vehicle handbook and note whether the vehicle

has a positive earth or negative earth.

2. The output cable from the charger terminates in a socket. Connect one of

the following leads into this socket.

CHARGING A NEGATIVE EARTHED BATTERY

1. Make sure that the black clamp is not touching the battery or the fuel line.

2. Connect the positive (+) red clamp to the positive (+) battery post

3. Connect the negative (-) black clamp to the negative (-) battery post or

vehicle chassis.

Crocodile clips - for connecting direct to the

battery terminals, positive (Red) and negative

(Black).

Cigar lighter lead - when you want to charge

the battery though the vehicle accessory

(cigar lighter) socket.

NOTE: Not all vehicles allow charging this way,

and doing so can damage the vehicles

electronic systems, see the vehicle

handbook for details on recommended

methods of charging the battery.

Lead (C) is for semi permanent connection to

the battery via eyelets. For motorcycles, Boats,

ATVs, Quad bikes and Scooter.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

CHARGING A POSITIVE EARTHED BATTERY

1. Make sure that the red clamp on the clamp lead is not touching the

battery or the fuel line.

2. Connect the negative (-) black clamp to the negative (-) battery post.

3. Connect the positive (+) red clamp to the positive (+) battery post or

vehicle chassis.

BATTERY NOT IN A VEHICLE

1. Connect the (+) red clamp to the positive (+) battery post.

2. Connect the (-) black clamp to the negative (-) battery post.

PERMANENT CONNECTION TO VEHICLE USING EYELET LEAD

1. Connect the eyelet on the red (+) wire to the positive (+) battery terminal.

2. Connect the eyelet on the black (-) wire to the negative (-) battery

terminal.

THE 3-STAGE CHARGING PROCESS

Stage Description

1 Bulk/Rapid Start Charge (20%-70% charge). The charger delivers

maximum charging amperage to re-energise the battery.

2 Absorption Charge (70%-90% charge) Maintains the charge at a

safe voltage, which remains constant while the current

requirement diminIshes.

3 Maintenance (90%-100% charge) Voltage is automatically

maintained with pulsing low input current. Occasional monitoring

only required.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

OPERATION

1. Connect the charger to the battery as instructed on page 6 before

connecting to mains power supply.

CONNECT CHARGER TO MAINS POWER SUPPLY

1. Insert the plug into the mains power supply.

2. Switch on the power supply.

• The “POWER” LED will illuminate.

• Depending upon the charger status, either the “CHARGING” LED or the

“FULL” LED will also illuminate.

3. When the “FULL” LED is lit and maintenance mode is not required,

disconnect the charger from the power supply, remove the clamps from

the battery in the reverse order they were fitted and keep in a safe, dry

area.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

MAINTENANCE

Other than cleaning, this charger does not require any specific maintenance.

CLEANING

Only use a dry cloth to clean the charger. DO NOT use solvents or cleaning

agents on the casing.

CHANGING THE FUSE IN THE CIGAR LIGHTER CONNECTION

WARNING: DISCONNECT THE CHARGER FROM THE MAINS POWER BEFORE

SERVICING OR PERFORMING ANY MAINTENANCE.

1. Unscrew the locking ring,

making sure that you don't lose

the nipple

2. Replace the 15A glass fuse and

reassemble the plug.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SPECIFICATION

Input Voltage 230V

Battery Voltage 12V

Compatible Battery Types Lead acid: SLA, WET, AGM, VRLA

Charging Current 2 Amp

Input Current 0.32 Amp

Charge Type 3-Cycle

Ambient Temperature -20°C to +50°C

Dimensions (D X W X H) 75 x 145 x 40 mm

Weight 0.5 kg

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Clarke Akkuladegerät Handbücher

Clarke

Clarke Start'N'Charge BC185N Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC260N Bedienungsanleitung

Clarke

Clarke IBC25 Bedienungsanleitung

Clarke

Clarke HFBC12-24 Bedienungsanleitung

Clarke

Clarke ZX-R Pro Series Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC100C Installations- und Betriebshandbuch

Clarke

Clarke IBC50 Bedienungsanleitung

Clarke

Clarke WBC400 Bedienungsanleitung

Clarke

Clarke IBC40 Bedienungsanleitung

Clarke

Clarke BC 700 Handbuch

Clarke

Clarke DIGICAR 600 Bedienungsanleitung

Clarke

Clarke ATC12VB Bedienungsanleitung

Clarke

Clarke IBC20 Bedienungsanleitung

Clarke

Clarke CBO9-12 Bedienungsanleitung

Clarke

Clarke Start n charge BC100B Bedienungsanleitung

Clarke

Clarke Start-N-Charge BC150 Bedienungsanleitung

Clarke

Clarke IBC4 Bedienungsanleitung

Clarke

Clarke WIBC250 Bedienungsanleitung

Clarke

Clarke ATC12V Bedienungsanleitung

Clarke

Clarke AC80 Bedienungsanleitung

Clarke

Clarke Start N charge BC100N Handbuch

Clarke

Clarke BC125 Bedienungsanleitung

Clarke

Clarke Start'N'Charge WBC180 Bedienungsanleitung

Clarke

Clarke CB09-6/12 Bedienungsanleitung

Beliebte Akkuladegerät Handbücher anderer Marken

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Bedienungsanleitung

Enelion

Enelion Vertica Bedienungsanleitung

RCA

RCA CHU6 Bedienungsanleitung

ANSMANN

ANSMANN ALCT 6/24-10 Bedienungsanleitung

Hitachi

Hitachi UC 18YRSL Fehlerbehebungshandbuch

Olympus

Olympus B-20 LPC Bedienungsanleitung

Exibel

Exibel ZH1708143 Bedienungsanleitung

Lenmar

Lenmar Mach 1 Bedienungsanleitung

CTEK

CTEK MXS 5.0 Bedienungsanleitung

ABB

ABB HT842379 Bedienungsanleitung

Nitecore

Nitecore Superb Charger SC4 Bedienungsanleitung

Renogy

Renogy RBC2125DS-21W Bedienungsanleitung

Braun

Braun BWC02M Bedienungsanleitung

CTEK

CTEK MXS 3.6 Bedienungsanleitung

Black & Decker

Black & Decker BDV090 Bedienungsanleitung

Trinity

Trinity DPD Bedienungsanleitung

Hulkman

Hulkman Sigma 1 Bedienungsanleitung

IKEA

IKEA koppla Bedienungsanleitung