Classic Exhibits Visionary DESIGNS MOD-1137 Bedienungsanleitung

www.classicexhibits.com

866.652.2100

WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL

SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING

Order #xxxxx - MOD-1137 Workstation Assembly

Item

Description

Tapered Panel w/ Door

Side Panel

Tapered Panel

Side Panel

Qty.

Item

Description

Base Plate

Right Leg Extrusion

Left Leg Extrusion

Vertical Extrusion for Monitor Mount Attachment

Qty.

Steps:

1) Attach left leg extrusions [3] to panel [2] and right leg

extrusions [2] to panel [4] using supplied screws,

see detail illustration below.

2) Attach leg assemblies to base plate [1] using bolts as shown.

Steps (Cont’d):

3) Assemble panels [1and 3] to panels

[2and 3] as shown.

4) Attach pins to back of panels [1and 3],

then set floor atop pins.

5) Velcro shelf supports to inside of

assembled base, then set shelf atop

supports.

6) Attach plate to underside of counter, and

secure with provided screws.

7) Attach vertical extrusion [4] to counter

using supplied bolt.

8) Set assembled counter atop assembled

base.

9) Attach monitor mount to vertical extrusion

where indicated, see monitor mount

attachment detail.

Modul Extrusion: Part List

EURO LT System: Part List

Monitor Mount Attachment

Attach monitor mount to vertical

extrusions after assembly.

Slide Mount

into Groove of

Vertical Extrusion.

Tighten

Setscrew Attach top

Plate and

tighten screws

Screws

Shelf Supports

Shelf

Counter Top

Step 1 Step 1

Step 2

Step 4

Step 5

Step 6

Step 7

Floor

Attach pins to lower BACK

side of panels [1and 3]

for floor placement.

Step 3

www.classicexhibits.com

866.652.2100

WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL

SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING

Order #xxxxx - General Information

The Tool

Typical Connection Horizontal Inline Connection (remove only one setscrew)

Base Plate Connection Vertical Connection

(remove only two setscrews)

Most exhibits can be assembled

with the supplied Hex Key Tool.

Occasionally, a flat head screw-

driver may be required.

Most horizontal extrusion connections have a patented expandable lock.

This lock inserts into the groove of an opposing extrusion. Tightening the

lock with the Hex Key Tool expands the lock and creates a strong positive

connection.

Remove only (1) setscrew when disassembling.

Replace setscrew in extrusion after assembling it.

Before packing, replace setscrew in extrusion to

avoid losing it.

Attach base plate to round or

square vertical extrusion using

the bolt provided. Be careful not

to strip the threads.

When vertical extrusions are

packed in portable cases rather

than crates or tubs, they must be

broken down into smaller sections

which then require assembly.

Remove only (2) setscrews when

disassembling. Replace setscrews

in extrusion after assembling it.

Before packing, replace setscrews

in extrusion to avoid losing them.

Using Your Setup Instructions

The Euro LT Hybrids Setup Instructions are created specifically for your configuration.

They are laid out sequentially in levels, including exploded views, and a logical series of

detailed steps to assemble the main structure and components. We encourage you to study

the instructions before attempting to assemble your exhibit.

Each page reminds you to tighten the setscrews after disassembling your exhibit to prevent loss of

the locks and setscrews (see below in RED). This is VERY IMPORTANT.

Cleaning and Packing Your Display

1) Use care when cleaning aluminum extrusion or acrylic inserts. Use only non-abrasive cleaners.

2) When cleaning laminate inserts, countertops, or panels use mild cleansers and a soft material such

as cotton.

3) Keep all display components away from extreme heat and long exposure to sunlight to avoid

warping and fading.

4) Retain all packing material. It will make re-packing much easier and will reduce the likelihood of

shipping damage.

Typical Connection (cont’d) Numbered Label

Each extrusion contains a numbered

label which corresponds with setup

instructions. The label is located within

a groove of the extrusion (when possible).

With extrusion components the labels

contain Black numbers unless otherwise

specified.

Detail C Detail D Detail EDetail B

Detail A

Setscrews

Cut Away View Of

Slide Clips

,EFT0ANEL

2IGHT0ANEL

Left Hand

Grasps Panel

Firmly

With Right Hand Thumb

Close to Seam

Squeeze,

Push Forward,

And Lift

Color Coded Clip

w/ assembly number

Panel Lock

When Required

Black Clip

is bottom of

panel

Connector Top View of Panels with LocksExample of Connection

Color Coded Clip

w/ assembly number

Panel Lock

When Required

Each component has 2 clips,

the lower clip is ALWAYS

black. The top clip is color

coded to distinguish the

level. The color coded clip

also contains the numbered

label.

Components connect together

by aligning them and sliding

downward connecting clips

together.

Configurations are assembled

from left to right, usually starting

with #1 and following the

numbered sequence.

The first level of components contains panel locks

that are located at the top of the panel for extra

stability and a seamless connection. When dis-

assembling panels, twist top connection slightly

and lift right panel upward.

General Setup Instructions for Extrusion System

General Setup Instructions for Panel System

Level 1 = Blue

Level 2 = Red

Level 3 = Green

Level 4 = Black

www.classicexhibits.com

866.652.2100

WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL

SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING

Order #xxxxx - Case Packing Instruction

Tapered Panel Literature Rack

and Hardware

Slip Sheet

Counter Top

Floor and Internal Shelf

Tapered Panel

Side Panel x 2

Base Plate

Round Extrusion x 5

Case 1 Case 2

Andere Classic Exhibits Inneneinrichtung Handbücher

Classic Exhibits

Classic Exhibits Euro LT Hybrids MOD-1246 Bedienungsanleitung

Classic Exhibits

Classic Exhibits eco systems ECO-4100 Handbuch

Classic Exhibits

Classic Exhibits visionary DESIGNS MOD-1180 Bedienungsanleitung

Classic Exhibits

Classic Exhibits VISIONARY DESIGNS VK-2959 Handbuch

Classic Exhibits

Classic Exhibits Perfect 10 Helio Bedienungsanleitung

Classic Exhibits

Classic Exhibits SYMPHONY SYM-406B Handbuch

Classic Exhibits

Classic Exhibits visionary DESIGNS VK-1131 Handbuch

Classic Exhibits

Classic Exhibits visionary VK-2098 Bedienungsanleitung

Classic Exhibits

Classic Exhibits Visionary Designs MOD-1243 Bedienungsanleitung

Classic Exhibits

Classic Exhibits SYMPHONY SYK-1025 Handbuch

Classic Exhibits

Classic Exhibits Euro LT Hybrids LTK-1012 Handbuch

Classic Exhibits

Classic Exhibits SYK-1029 Handbuch

Classic Exhibits

Classic Exhibits VISIONARY DESIGNS VK-1214 Bedienungsanleitung

Classic Exhibits

Classic Exhibits visionary MOD-1294 Bedienungsanleitung

Classic Exhibits

Classic Exhibits MAGELLAN DESIGNS VK-1088 Bedienungsanleitung

Classic Exhibits

Classic Exhibits VISIONARY DESIGNS VK-1201 Bedienungsanleitung

Classic Exhibits

Classic Exhibits Euro LT Hybrids LTK-1011 Bedienungsanleitung

Classic Exhibits

Classic Exhibits Perfect 10 Bella Bedienungsanleitung

Classic Exhibits

Classic Exhibits LTK-1139 Bedienungsanleitung

Classic Exhibits

Classic Exhibits SYMPHONY SYM-408B Handbuch

Classic Exhibits

Classic Exhibits Symphony SYK-2005 Handbuch

Classic Exhibits

Classic Exhibits Symphony SYK-1019 Handbuch

Classic Exhibits

Classic Exhibits VISIONARY DESIGNS MOD-1722 Handbuch

Classic Exhibits

Classic Exhibits SACAGAWEA DESIGNS VK-1222 Handbuch

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung

Classic Exhibits visionary DESIGNS MOD-1137 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken