17-03-T
Installation Instructions
15121437-C 2
1
Turn the water supply off and remove
the mud guards.
5
Pull the diverter rod and knob up and
down to test the connection.
2
Connect the diverter rod extension to
the diverter rod in the diverter spout
nipple.
4
From the back of the spout insert the
diverter knob into the spout and
carefully place it on the diverter rod.
Secure the knob with the setscrew.
7
Pull black nylon or finished hose
through the hand shower nipple
bracket. Slide the hand shower
bracket and hose guide over the
hose. Secure the assembly with the
thread. Note, make sure the hose
does not slip under the deck.
6
Align the handle and place the handle
and escutcheon assembly onto the
valve. Secure the assembly by
turning the escutcheon clockwise.
Repeat for the other valve.
9
8
Remove the aerator with the supplied
key. Turn the water supply on.
15121437-C 3
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry
any overspray. This will maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the
product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup.
Follow instructions to ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners,
cleansers or disinfectants will alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and
glass cleaners to remain on the surface. Prolonged contact will alter surface finishes and void the warranty.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.
Cleaning Instructions
3
Place the spout “O” ring under the
spout and install spout on spout
nipple-diverter assembly. Be sure the
spout is firmly resting on the deck.
Secure the spout with the setscrew.
9
Make sure the diverter knob is in the
down position. Turn the faucet
handles on full for one minute to
flush debris.
10
Leaving the water on, pull the hose
to its farthest extension and point it
into the tub. Pull the diverter knob to
its top position. Flush the debris for
one minute. Turn off the valves.
11
Attach the hand shower to the black
nylon or finished hose.
12
Re-install the aerator with key.
13
Installation complete.
Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our
website.
For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: 508-381-0433 fax: 508-381-6068
www.crosswaterlondon.com
email: technical@crosswaterlondon.com
Issue date: 18112019
