180 mm
43
1
2
5
SAFETY
NOTE!
WATER PRESSURE
This mixer is suitable for high-pressure plumbing systems only with
minimum pressure of 1 bar. However for optimum use both the hot
and cold supplies should be reasonably balanced.
This mixer should be installed in compliance with Water Regulations.
Where the supplies are unbalanced, i.e. hot water from cylinder
tank/cold from the mains, approved check valves must be fitted in the
supply pipes. For further details contact your Local Water Authority.
Please Note:In the unlikely event you find a part missing please
contact our Customer Service Help line on 0844 701 6273 for
immediate dispatch of part.
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging fitting.
2. Fit the mixer body (1) to the bath using the backnuts (2) below and
the washers (3) above the bath, then connect the hot and cold water
supplies.
3. Fit the hose (4) to the mixer and the handset using the small
sealing(5)washers.
4. To fit wall bracket, position, mark out and drill holes to suit,
then screw wall bracket to the wall, ensuring that the
handset will reach it.
5. Fully open the mixer in the mid position, letting it run for a few
minutes and check all joints and connections for leaks.
6. Operate the mixer in both bath and shower mode.
To switch from bath to shower mode pull the diverter up. After use
the mixer automatically reverts to the bath-filling mode.
7. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1. Isolate water supplies.
2. Prise out handle cap (at back of handle), loosen grub screw and lift
off the handle.
3. Unscrew the shroud and brass retaining plate and lift out the
cartridge complete with seal.
4. Clean or replace cartridge, clean and grease seal and refit.
Note:that there are locating pins on the bottom of the cartridge that
fit in holes inside the tap, to ensure it is fitted the right way round.
5. Refit the handle and tighten the grub screw. Replace the handle
cap.
6. If problem persists contact our helpline quoting the product code.
1. Body (x1)
2. Backnut (x2)
3. Washer (x2)
4. Hose (x1)
5. Sealingwasher (x2)
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk
