Pfeiffer Vacuum EVL 063 P Bedienungsanleitung
Operating manual
BP 805 030 BE (9902) 1
Angle valve
with control valve
with position feedback
EVL 063 P
EVL 100 P
EVL 160 P
Safety
Technical data
Installation
Operation
Maintenance
Repair
Decommissioning
2General BP 805 030BE (9902) EVL 063–160 P
In all communications with Pfeiffer Vacuum please specify the information given
on the nameplate. For convenient reference transfer this information into the
diagram below.
Typ:
No:
F-No:
V: Hz:
Pfeiffer Vacuum, D-35614 Asslar
This manual applies to manuals with part number
PF B18 701 (EVL 063 P)
PF B28 701 (EVL 100 P)
PF B38 701 (EVL 160 P)
The part number can be taken from the nameplate.
The functions described as well as the illustrations and data contained in this
manual are subject to change without notice.
The Angle valves described in this manual are used as shut off valves in vacuum
systems and vacuum pumping stations.
The Angle valves are opened by a compressed air piston and closed by at least
one pressure spring. They close automatically in the event of a power or com-
pressed air failure.
The Angle valves have a floating switchover contact for both final positions.
Product identification
Validity
Intended use
Functional principle
BP 805 030BE (9902) EVL 063–160 P Safety 3
1 Safety
DANGER
Information on preventing any kind of personal injury or extensive equipment
damage.
CAUTION
Special information on damage prevention.
Specialists
This work may only be carried out by persons with suitable technical training and
the necessary experience.
NOTE
Special information on cost-effective use.
Result O.K.
Result not as expected
Do not dispose of
→2See page ...
a) Take into account the relevant safety regulations for the gases used.
Consider possible reactions with the materials (→24).
b) Take the necessary precautions when doing installation, maintenance, or
repair work (→26, 8, 10,14).
c) Products returned for maintenance or repair should if at all possible be free of
harmful substances (e.g. radioactive, toxic, caustic, or microbiological). Other -
wise, the type of contamination has to be declared.
Products that are not clearly declared as "free of harmful substances" are
decontaminated at the expense of the customer.
Pass on the safety information to other users.
Pfeiffer Vacuum assumes no liability and the warranty becomes null and void if the
operator or third parties
• use the product in a nonconforming manner
• disregard the operating manual
• make any kind of changes (modifications, alterations, etc.) to the product
The operator assumes the responsibility in conjunction with the gases used.
1.1 Explanation of symbols
1.2 Safety information
1.3 Responsibility and
warranty
4Technical data BP 805 030BE (9902) EVL 063–160 P
2 Technical data
EVL 063 P EVL 100 P EVL 160 P
Flange connection DN 63 ISO-K DN 100 ISO-K DN 160 ISO-K
Operating voltage V≅24...240 24...240 24...240
Protection class IP 50 IP 50 IP 50
Noise level dB (A) <70 <70 <70
Conductance for air (molecular flow) l/s 160 450 1000
Tightness mbar l/s 1×10-9 1×10-9 1×10-9
Mounting orientation any any any
Max. frequency 1/min. 30 30 20
Cycles to first maintenance 1,000,0001)1,000,0001) 1,000,0001)
Pressure difference ∆p
in closing direction
in opening direction bar
bar 3
23
23
2
Pressure range mbar ... bar 1×10-8 ... 5 (abs.) 1×10-8 ... 5 (abs.) 1×10-8 ... 5 (abs.)
Can be opened to a pressure difference
∆p of bar 3 3 3
Closing time ms 7502)5002) 7502)
Opening time ms 3003)6003) 15003)
Compressed air
overpressure
volume bar
cm³ 4...8
115 4...8
225 4...8
575
Starting current mA 13 13 13
Holding current mA 0.1...3.5 0.1...3.5 0.1...3.5
Load capacity of the position feedback
switches V=
A25
225
225
2
Ambient temperature °C 54)...50 54) ...50 54) ...50
Bakeout temperature
housing
actuator
control valve
°C
°C
°C
150
60
60
150
60
60
150
60
60
Materials
housing Al alloy
3.2315 Al alloy
3.2315 Al alloy
3.2315
bellows stainless steel
1.4301 stainless steel
1.4301 stainless steel
1.4301
seals Viton Viton Viton
Dimensions →25 →25 →25
Weight kg 3.7 7.5 15.4
1)under clean operation conditions
2)compressed air 5 bar (abs.)
3)compressed air 9 bar (abs.)
4) –15°C, if the ambiance is free of condensable gases
BP 805 030BE (9902) EVL 063–160 P Technial data 5
Fig. 2.1
DN 63 ISO-K
260
88
237
197
20
12°
16°
DN 63 ISO-K
Fig. 2.2
DN
H
A
E
DN
12°
15°
G
Z
ADEGHZ
DN 100 ISO-K 108 ø152 293,5 264,5 316,5 25
DN 160 ISO-K 138 ø204 355 313 378 35
Electrical connection
Position feedback connection
Compressed air connection G1/8"
Position indicator
Protective cover
Valve seat side
Leak detection port
EVL 063 P
EVL 100 P
EVL 160 P
6Installation BP 805 030BE (9902) EVL 063–160 P
3 Installation
NOTE
Make sure to adhere to the special regulations concerning cleanliness and
damage prevention when working with vacuum components.
èRemove the protective covers
The protective covers may be needed for maintenance or repair.
Fig. 3.1
Make the flange connections
Clamping flange /
clamping flange Collar flange /
fixed flange Clamping flange /
baseplate
Nominal diameter Number of
clamping screws Number of screws Number of claw
grips
DN 63 ISO-K 4 4 4
DN 100 ISO-K 4 8 8
DN 160 ISO-K 4 8 8
Please refer to the catalog for further details.
DANGER
When using compressed air make sure to adhere to the applicable handling and
safety measures.
CAUTION
The compressed air must meet the following requirements:
• free of oil
• dry
• free of particles >10 µm
• overpressure 4 ... 8 bar
3.1 Making the flange
connections
3.2 Connecting the
compressed air
BP 805 030BE (9902)) EVL 063–160 P Installation 7
G1/8"
Fig. 3.2
Fig. 3.3 G1/8"
Fig. 3.4
G1/8"
G1/8"
Fig. 3.5
EVL 063 P
Funneling the vent in a common
exhaust duct
EVL 100 P
EVL 160 P
Funneling the vent in a common
exhaust duct
Fast venting with muffler
to common exhaust duct
to common exhaust duct
to common exhaust duct
The compressed air
tube must withstand at
least 10 bar
The compressed air
tube must withstand at
least 10 bar
Venting with muffler
8Installation BP 805 030BE (9902) EVL 063–160 P
èMake the connection cable (matching connector enclosed)
Wiring dia-
gram inside
the cap
24...240 V≅
Fig. 3.6
Normally open contact
(valve open)
234
5
16
7
CAUTION
Load capacity of
the position feed-
back switches:
25 V= / 2 A
Normally closed
contact
(valve closed)
Make the electrical connection
DANGER
The valve may only be connected to the electric power supply if:
• if the angle valve is installed in a vacuum system
• the moving parts (valve plate etc.) are protected against accidental
contact.
The controller must be turned off before the valve is connected or dis-
connected.
The mains connector may only be plugged into a socket with a protective
ground. The protection must not be nullified by an extension cable without
ground conductor.
Fig. 3.7
3.3 Electrical connection
Connect according to
the local safety
regulations
Control contact
BP 805 030BE (9902)) EVL 063–160 P Operation 9
4 Operation
Position of the valve plate Optical valve position
indicator
Medium not active
lMedium active
Fig. 4.1
Pressure range
EVL 063 P
EVL 100 P
EVL 160 P 1×10-8 mbar ... 5 bar (abs.)
Fig. 4.2 Pressure difference ∆p = 2 bar
4.1 Position of the valve
plate as function of the
media
4.2 Pressure range and
pressure difference
Pressure difference
∆p = 3 bar
Compressed
air Voltage at
the control
valve
l
l
ll
10 Maintenance BP 805 030BE (9902)) EVL 063–160 P
5 Maintenance
Under clean operating conditions the product requires no maintenance during the
rated cycle life (→24).
DANGER
Neither the operator nor third parties shall perform maintenance work not
described in this manual.
DANGER
Persons performing maintenance work must first receive information concerning
the state of the contaminated vacuum units and their components.
Before installing or removing the product and for all maintenance work, the elec -
tric power and the compressed air supply have to be interrupted.
The connection to the compressed air and to the electric power may only be
established if:
• the angle valve is installed in a vacuum system or
• the moving parts (valve plate etc.) are protected against accidental contact
Please note that loaded springs and air cushions in the cylinder represent
potential hazards even when the supply lines are disconnected.
When using cleaning agents make sure to adhere to the applicable handling and
disposal regulations and safety measures.
NOTE
Make sure to adhere to the special regulations concerning cleanliness and
damage prevention when working with vacuum components.
èAssess the accessibility of the product
A
Fig. 5.1
Replacing the seals of the valve
plate and the housing
Preparation
easily accessible →, , ò, ó
not easily accessible →... ó
AøD
EVL 063 P ≈250 ≈200
EVL 100 P ≈300 ≈250
EVL 160 P ≈350 ≈300
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere Pfeiffer Vacuum Steuereinheit Handbücher
Pfeiffer Vacuum
Pfeiffer Vacuum EVA 016 H Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum TPG 361 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum UVH 040 CU Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum UDV 046 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum TPG 500 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVA 016S Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum RVG 050 C Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum UDV 040 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVB 160 PA Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVI 005 MI Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVB 016 Series Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum TPG 366 MAXIGAUGE Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVB 16 P A Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum PM Z01 295 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum PM Z01 310 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVN 116 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVB 016 S A/X Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVB Series Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum EVR 116 Bedienungsanleitung
Pfeiffer Vacuum
Pfeiffer Vacuum AVA 016 Bedienungsanleitung
Beliebte Steuereinheit Handbücher anderer Marken
Festo
Festo Compact Performance CP-FB6-E Stücklistenhandbuch
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung
JS Automation
JS Automation MPC3034A Bedienungsanleitung
JAUDT
JAUDT SW GII 6406 Series Kurzanleitung
Spektrum
Spektrum Air Module System Bedienungsanleitung
BOC Edwards
BOC Edwards Q Series Bedienungsanleitung
