Oneida Air Systems Super Dust Gorilla Bedienungsanleitung

OneidaAir Systems, Inc. 1001 West Fayette St., Syracuse, NY13204

Phone 1.800.732.4065 315.476.5151 Fax 315.476.5044 www.oneida-air.com

Shown with

optional Stand.

Models may vary slightly

in appearance.

6_10

SuperGorillaOwner’sManual

2hp50Hz

CyclonicDustCollector

2hp50Hz

2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

Thank You for Choosing an Oneida Air Systems Product!

OAS manufactures and sells dust collection equipment only. Our qualiﬁed technicians and sales staff are available

7:30am - 6:00pm EST Mon. -Thurs. and 7:30am - 5:00pm EST Fri. to answer any questions concerning OAS products

and dust collection. Call for ductwork design and ductwork quotes, including system pricing and shipping cost.

Read the entire Owner’s Manual before installing or operating system!

Proudly Made

in the USA

II.

III.

IV.

VI.

VII.

VIII.

IX.

XI.

XII.

XIII.

XIV.

XV.

XVI.

XVII.

XVIII.

System Start-Up Information

Commercial Conﬁgurations

General Speciﬁcations & Fan Performance Curve

Dimensions

General Assembly

General Assembly Instructions

Bracket Assembly

Filter Assembly

Filter Maintenance

Directions for Cleaning External Filter & Clipping Dust Pan

Fan / Blower Wiring Diagram

Troubleshooting

Fire Hazards - Read Before Installing System

Terms and Conditions

Stand Assembly

Accessories

Fan Motor Maintenance

Optional Remote Controller Diagram

TableofContents Page

22hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

I.SystemStart-UpInformation

The Dust Collector & Fan / Blower is heavy! Handling and installation should always be performed

by experienced and trained personnel who have experience with rotary equipment. In addition to

the following instructional manual, care should be taken to ensure compliance with speciﬁc safety

requirements mandated by federal, state and local codes.

1. Read the installation and maintenance instructions as well as the recommended safety practices in this

manual

3. Motor is pre-wired at the factory. If magnetic starter trips circuit, check the following:

1. Dust drum securely fastened to discharge of cone?

2. Is ductwork installed at cyclone inlet?

2. Install ductwork completely before operating collector:

A.) Seal ductwork with silicone sealant or duct tape.

B.) Have dust bin in place and sealed.

Caution

Warning

Do not operate Fan / Blower unless Fan Housing is attached to Cyclone body and Dust Drum is in

place. Dust Drum and Cyclone must be in place and sealed or motor will overheat!

If amperage is too high - shut down immediately! See Troubleshooting section.

2hp 50 hz Super Gorilla Owner’s Manual © O.A.S. 2010

II.Super DustGorillaConﬁgurations

Shown with

optional Stand.

1. External Cartridge Filter - Silencer Included with Filter

Caution:

Cartridge Filter Media

If exhaust air is vented outside you must provide make up / return air.

Flue gases (carbon monoxide) can be drawn into the shop from furnaces,

water heaters or other appliances.

99cm / 8.83 Sq. Meters

GE H12 Certiﬁed HEPAﬁlter media.

42hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

III.GeneralSpeciﬁcations&FanPerformanceCurves

2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

IV.Dimensions

For Minimum Mounting Heights w/ 99 cm Filter

*Dimensions subject to slight variation in manufacturing.

2 & 2.5hp -

92.00”

33 cm

33.0 cm

123 cm

61.6 cm

67.5 cm

Allow 2.5 - 5 cm from ceiling

231.1 cm

191.8 cm

168.9 cm

142.2 cm

40.0 cm

20.3 cm

99.0 cm

15.2 cm

132.5 liter shown

Add 33 cm for 208.2 liter 10 cm

62hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

V.GeneralAssembly

Optional 35 & 55 Gal. Stand

(4) Rubber Leg Caps - RCR012500

(4) Top Gussets - RFG010000

(4) Mid-Gussets - RFG010001

(4) Stand Braces - SXX000000

(4) 35 Gal. Leg Set - SXX000035 or

(4) 55 Gal. Leg Set - SXX000055

Stand Hardware Kit -

AHX000100

(16) 1/4”-20 x 2” bolts

(16) 1/4”-20 x 3/4” bolts

(32) 1/4” ﬂat washers

(32) 1/4”-20 Nylock nuts

f9. (16) Clips -AFT051618

AHX000001

f10. (16) Flange Bolts -AFB155155

(8) 5/16” Clips

(8) 5/16” Bolts

(8) 5/16” Clips

(8) 5/16” Bolts 5i

5i. Filter Plate - (13”) FPX010013 / (18”) FPX010018

6. Filter - (2hp) FCS133995 / (2.5hp) FCS183900

5g. Internal Silencer - (2hp) BSC130000 /

(2.5hp) BSC180000

5b. J - Hooks (8) -AFJ051602 /AFT000001

5a. Plenum - FPX000001

4. Cyclone Cone - SCX002105 / SCX025105

1a. 2hp motor - BMZ020105 / 2.5hp - BMZ025105

1. MotorAssembly - (2hp) BXI002105 / (2.5hp) BXI002505

5e. Dust Bin - (13”) FPZ000013 / (18”) FPZ000018

2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

VI.AssemblyInstructions

Clips - AFT051618

Motor Plate

Gasket

Material

Gasket material goes

outside of clip holes

on top and bottom of

fan housing.

Gasket

Material

Collector

Barrel

Fan

Housing

Washer

Bolt

Clip

Instructions for assembly of the Fan Blower Housing and Barrel of the Oneida Models.

1. Push clips onto inside circle on Fan Housing, making sure clip is pushed all of the way on, that the bolt

holes are in alignment with the clip holes and that the small barrel on the clip is on the INSIDE of the Fan

Housing as shown in diagram.

2. Stick the gasket material around the Fan Housing as shown in the diagrams, outside of the bolt circle.

Making sure of a complete seal. Dust collection systems cannot operate effectively without being tightly

sealed with no air leaks.

3. Put bolt through washer. then into appropriate bolt holes in Fan Housing and Barrel. Tighten bolts so

they all are snug, then go back and ﬁnish tightening the bolts in a star pattern.

Proportions and sizes of parts may be

exaggerated for purposes of explanation.

It is CRITICAL that this part

of the clip is put on the inside

of the Fan Blower Housing as

shown here. Otherwise you

will not get the seal needed for

complete dust collection!

2hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

VI.GeneralAssemblyInstructions Do NOT use hook on motor to lift unit.

There are essentially three ways to assemble your collector and to at-

tach it to the stand. The way that is right for you should be determined

by expertise and manpower available. When the units are all assem-

bled they are very heavy and top weighted.All of this should be taken

into account before deciding on the method best suited for you.

With all assemblies, make sure rectangular air

outlet is oriented on Fan/Blower housing as

you are looking down as in Fig. 1Aor facing it

as shown in diagrams. This is very important.

Then you can rotate the housing to whatever bolt

position is best for your shop.

Before you start, make sure you have read the directions thoroughly.

Bolt Fan / Blower housing to Cyclone barrel, Then bolt Motor and

Plate to Fan/Blower housing. Carefully lay unit on its side and then

bolt cone to barrel. Lift entire unit up onto stand. Unit is extremely

heavy and top weighted, be advised!

Bolt Fan / Blower housing to Cyclone barrel, Then bolt Motor and

Plate to Fan/Blower housing. Put Cone up on stand and orient holes.

Lift assembled unit onto cone making sure proper holes are lined up.

Bolt unit to stand, then ﬁnish bolting barrel to cone.

Bolt Fan / Blower housing to Cyclone barrel, Put Cone up on stand

and orient holes. Lift assembled unit onto cone making sure proper

holes are lined up. Bolt unit to stand, then ﬁnish bolting barrel to

cone. Lift Motor & Plate onto Fan/Blower housing and bolt together in

proper direction.

Method #1 -

Method #2 -

Method #3 -

If you are having trouble getting your drum out

to empty it, you can cut down the ﬂex hose to

give yourself more room. Just make sure that the

drum lid tightly seals to the drum and that there

are no leaks in the ﬂex hose connection.

92hp 50hz Super Gorilla Owner’s Manual © O.A.S. 2010

Andere Handbücher für Super Dust Gorilla

Inhaltsverzeichnis

Andere Oneida Air Systems Staubabscheider Handbücher

Oneida Air Systems

Oneida Air Systems Smart Dust Collector Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems XCKM010000 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Super Dust Gorilla Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems 10 HP Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems XSK000114 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Supercell Mobile Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems 5 & 7.5 HP Direct Drive Cyclonic Dust... Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems V - 2000 2hp Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Smart Pro XXS200001 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems XXK100300 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Dust Gorilla Pro Smart Boost... Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Dust Cobra Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems BenchTop Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems V1500 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Dust Cobra Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems XCKM013000 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems XXS050333 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Supercell Mobile Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Dust Cobra - XCK010000 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Supercell XSK000014 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Gorilla XXP999901 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Mini GORILLA XXP010101 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Dust Deputy AXD000004 Bedienungsanleitung

Oneida Air Systems

Oneida Air Systems Pro 1500 Bedienungsanleitung

Beliebte Staubabscheider Handbücher anderer Marken

Fein

Fein 9-88-35 Bedienungsanleitung

Blastrac

Blastrac BDC-44 Bedienungsanleitung

DIVERSITECH

DIVERSITECH WB-4000-D Handbuch

National

National 3402 Bedienungsanleitung

Grizzly

Grizzly G0850 Bedienungsanleitung

Bosch

Bosch GDE18V-16 Montageanleitung

Grizzly

Grizzly G0441HEP Bedienungsanleitung

Storch

Storch Cover Quick Wall Bedienungsanleitung

laguna

laguna C FLUX 1 Bedienungsanleitung

GMC

GMC RDC8LA Bedienungsanleitung

Jet

Jet DC-1100VX Series Service-Handbuch

Showa

Showa Fumeresa CBA-1000AT-HC-DSA-V1 Bedienungsanleitung

King Industrial

King Industrial KC-4043KWRC Bedienungsanleitung

Jet

Jet 500 Bedienungsanleitung

Shop fox

Shop fox SHOP FOX W1687 Bedienungsanleitung

Blastrac

Blastrac 655DC Bedienungsanleitung

Elektra Beckum

Elektra Beckum Multi 180A Bedienungsanleitung

Grizzly

Grizzly G0508 Kurzanleitung